How to control the temperature when manufacturing plastic drums

Plastic bucket is a product that we are all familiar with, and we often use it in our daily life, then the problems that arise in its manufacture

Is everyone clear? The system piping is too thin and too long, too much bending, local pressure loss and pressure loss along the way. Component fine

Insufficient degree and poor assembly quality, large mechanical friction loss between relative movements. The fitting clearance of the fitting is too small, or use wear

Afterwards, the gap is too large, and the internal and external leakages are large, resulting in a large volume loss. For example, the volumetric efficiency of the pump decreases and the temperature rises quickly.

  The plastic barrel selects the fixed pump oil supply system of the oil pump capacity according to the fast forward speed, and most of the excess flow will be high when working

Press down to overflow from the relief valve and generate heat.

  The unloading circuit in the system is faulty or because the unloading circuit is not provided, the oil pump cannot be unloaded when the work is stopped, and the full flow of the pump

Overflow under high pressure causes overflow losses and generates heat, resulting in temperature rise.

  The volume of the plastic drum oil tank is too small, the heat dissipation area is not enough, and the cooling device is too small. The climate and operating environment temperature is high,

This causes the oil temperature to rise. The viscosity of the selected oil is improper, the viscosity is large, the viscosity resistance is large, and the viscosity is too small, the leakage increases, two cases

All can cause fever and temperature rise.

200 liter plastic bucket, 100 liter plastic bucket, 50 liter plastic bucket